Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover)

Need orange5 in-circuit wiring diagram for XC2361A-56 mcu in Airbag module BJ32-14D374-AC (2013 Land Rover).
Here is the photo of the board attached.
orange5 in circuit wiring diagram 01 - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover) - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover)

Here is the other side attached.
orange5 in circuit wiring diagram 02 - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover) -

It is confirmed that RST and TRST and Reset are the same.
Here is two pinout diagram i found . They both looks like the same in regards to connection points for programmer.
So here are the conversion from Orange5 to the pinout below.

Orange 5 Pinout diagram below:
GND GROUND
RXD TDI ( GREY)
TXD TDO ( ORANGE)
RST RESET (WHITE)
OSC TCK ( BLACK)
PDX TMS ( YELLOW)
VCC TO 5 volt ( NOT NEEDED FOR THIS MODULE)
If any problem, please re-check the soldering for the pinsout, also check the settings in the software, check usb port settings.
Note: Please apply 12 volt supply
orange5 in circuit wiring diagram 03 - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover) - orange5 in circuit wiring diagram 04 - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover) -

Update:
The diagram provided are wrong .. you will end up bricking the ecu!!!
short ground to the board in 2 places
log1 needs connecting and lift up pins 60&62 from mcu

Anyway, you can refer to the label on Orange 5 device.
orange5 in circuit wiring diagram 05 - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover) -

Any question on Orange 5 device, please contact at www.obdexpress.co.uk.

(Visited 1,201 times, 1 visits today)
favicon - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover) - Orange5 in-circuit wiring diagram for XC2361A-56(2013 Land Rover)