Launch X431 IMMO Plus/IMMO Elite with IMMO function matched anti-theft smart key for Peugeot 308 all keys lost no issues. Only takes about 2~3 Mins!
Main steps:
Step 1: Read anti-theft key password
Step 2: Match anti-theft key
Make sure the connection between the X431 IMMO device and vehicle is correct.
Connect the internet and ensure the network connection is normal during the operation process.
Step 1: Read anti-theft key password
Select IMMO>> Peugeot V10.22> Peugeot>> Anti-theft Key Password Reading>> All Lost Anti-theft Password Reading>> BSI>> Automatic scan
Note:
1.BSI Control unit voltage too low is likely to cause function failure. Make sure the battery is fully charged.
2.lnternet is needed to perform this function. Make sure the device has normal access on WIFI connection.
Press the double-flash switch
[Wiper start], [headlamp ON] are normal when performing this function. If you mind it, plugging out fuse at relative position will prevent it from starting.
Read out the anti-theft key password successfully
Write it download to use later
Step 2: Match anti-theft key
Select “Anti-Theft Key Matching”
Read out the VIN and car model
Select “Automatic scan”
Identify the VIN, mode, car model and system
Select “Programming Of Keys”
To program the keys, you must have:
-Of the confidential code.
-All of the vehicle’s keys.
Warning:
The keys which are not programmed during this programming procedure will no longer be able to start the engine.
If a new key is required, all keys can be reprogrammed.
To carry out programming of the keys, electronic keys or hands-free remote controls, enter the confidential code.
Warning:
If an error is made when entering the confidential code, programming will be forbidden.
You can confirm the confidential code using the specific procedure for your country.
Whether you are in the process of downloading, replacing, or initialising the BSI, the diagnostic tool will automatically use the code already entered at the time of the initialising of the confidential code.
Enter the 4-digit confidential code, enter it again to confirm
Confidential code is correct. The built-in systems interface is ready for programming of the keys or hands-free remote controls.
Enter the key number to be learnt (i.e.2)
Switch off the ignition
You have 15 seconds within which to switch on the ignition positive (+APC) using the key to be programmed.
Program the first key successfully with X-431 IMMO Plus
Switch off ignition and remove key
Insert the next key in the ignition, and repeat the above same steps to program
Key programming is completed, now the numbers of key programmed is 2.
IMPERATIVE:
Before making any attempt to start the engine:
Check that the handbrake is on.
For an automatic gearbox, check that the gear lever is in position ‘p’ (park).
For a manual gearbox, check that the gear lever is in neutral.
Done!
Launch X-431 IMMO Plus/X-431 IMMO Elite key programmer also performed anti-theft smart key matching on Peugeot 408 all keys lost successfully.
Peugeot 408 All Keys Lost Programming with Launch X431 IMMO Plus/ Elite