It has been tested and verified that Launch X431 X-Prog3 with PC Adapter can clone ISUZU Bosch MD1CS089 ECU in Bench mode perfectly. No need X431 tablet.
Direct connection diagram:
Follow the diagram in the X-Prog3 PC Adaptor PC software to connect Launch X-Prog3 PC Adapter and ISUZU ECU, and then connect PC Adapter to X431 X-Prog3 key programmer and computer properly
Menu path:
Input “md1cs089” in the search box to find the corresponding car model (Isuzu D-Max 2005-2020 MD1CS089 ECU)
Select “BENCH” connection type and click “Next”
Ensure the device connection is correct, and start to perform the reading and writing functions.
Back up the original ISUZU MD1CS089 ECU data:
Connect>> Read EEPROM data >> Read FLASH data>> Disconnect
Note: Remember to save the original EEPROM data and Flash data after reading
Back up the new ISUZU MD1CS089 ECU data:
Repeat the same steps as original ECU to back up the new ECU data
Finally, write the original ISUZU MD1CS089 ECU data into the new ECU
Alright! ISUZU MD1CS089 ECU is cloned by Launch X431 X-Prog3 and PC Adaptor successfully!
