Launch X431 PAD V test report: Ford C-CM reprogramming, Ford control module manual programming using AsBuilt Data.
Symptoms:
Pre-collision assist not available
Tire pressure sensor malfunction
Plug X431 PAD V to the 2018 Ford Mustang, select “Intelligent Diagnose”.
Then Ford V48.69 (the newest version)
Then “Automatically Search”.
Alright, we have the abnormal system. C-CM, BCMII etc.
Firstly go to troubleshot C-CM (Cruise-Control Module).
Back to enter “Special Functions”, then “Programmable Module Installation” (to set new module configuration parameters. )
Browse motorcraftservice.com/AsBuilt
Back to X431 PAD V, manually input AsBuilt Data.
Make sure the car programming with door open (driver side).
Set ignition switch to OFF (Position 0).
Install a new module in vehicle (ECU).
Set the ignition switch to ON.
Module programming processing… please wait 5 seconds.
Procedure succeed.
Set ignition switch to OFF (Position 0).
Alright, back to check if any fault code with cruise control module, the result is No fault code.
Turn on the dashboard, there is no malfunction symbol.
Job is done!
PS: And Launch X431 Pad V is an old X431 product, we recommend the latest product Launch X431 Pad VII in 2021
