Solution for New KT200 KTsuit Software Failed to Select Driver and Language

Customer problem:

I connected new kt200 and my laptop via usb cable, and installed the ktsuit manager program and ktsuit software with the internet. But when I wanted to r/w my car (it’s vw spc5777 mg1cs001), I clicked select driver and the language Portugues, there were no response, and the operation interface was in grey and could not do anything.

new kt200 ktsuit software cannot select driver solution 1 - Solution for New KT200 KTsuit Software Failed to Select Driver and Language - Solution for New KT200 KTsuit Software Failed to Select Driver and Language

new kt200 ktsuit software cannot select driver solution 2 - Solution for New KT200 KTsuit Software Failed to Select Driver and Language - Solution for New KT200 KTsuit Software Failed to Select Driver and Language

obdexpress.co.uk engineer gives the solution below:

Don’t close the KTsuit manager before your run KTsuit testing software, always keep clicking the active button before you run the ktsuit software.

Open KTsuit software and enter the key (device SN) to login again.

new kt200 ktsuit software cannot select driver solution 3 - Solution for New KT200 KTsuit Software Failed to Select Driver and Language - Solution for New KT200 KTsuit Software Failed to Select Driver and Language

 

If you have the same problem of New KT200 ECU Programmer, try to solve it with the method above.

Hope it helps!

 

www.obdexpress.co.uk

(Visited 70 times, 1 visits today)
favicon - Solution for New KT200 KTsuit Software Failed to Select Driver and Language - Solution for New KT200 KTsuit Software Failed to Select Driver and Language