How to Configure SUPER MB PRO M6+ PRO for BENZ & BMW?

This is a guide for SUPER MB PRO M6+ PRO Mercedes-Benz & BMW configuration step by step.

 

1. Plug the M6+ PRO into the power supply or connect the OBD to the test vehicle, and plug in the USB/LAN cable of the M6+ PRO.

 

2. Turn on the computer and plug in the computer USB/LAN cable.

 

3. Open the computer network configuration interface and find the Realtek USB FE Family Controller network/the network adapter that comes with the PC.

 

4. Click “Properties”–TCP/IPV4, and set the IP address as shown in the figure below.

 

5. Click “Advanced”, and add a group of network IP addresses as shown in the figure below.

TCP/IP Address

IP address: 172.29.127.45

Subnet mask: 255.255.0.0

 

6. Click “OK”. After the configuration is successful, the display is as follows.

 

7. For the same computer, if you replace a new M6+ PRO, you need to reset the IP address. After the setting is completed, the computer is successfully bound to the M6+ PRO and there is no need to set the IP address again for wired and wireless Internet access. (Use LAN port connection mode, no need to re-set IP when changing devices).

 

8. You can test Mercedes-Benz normally. Please connect the diagnostic cable with SUPER MB PRO

 

9. BMW wireless BMWAiCode configuration(only for F+G chassis)

Connect to the M6+ PRO -***, password: 123456789, wirelessly, press and hold the M6+ PRO switch button for 3 seconds, and the M6+ PRO host wireless indicator will flash. The computer-side BMWAiCoder configuration is as follows:

 

10. BMW wired BMWAiCode configuration(only for F+G chassis)

Connect the USB/LAN cable, press and hold the M6+ PRO switch button for 3S, and the M6+ PRO host wired indicator light will flash. The computer-side BMWAiCoder configuration is as follows:

 

11. BMW wired and wireless E-Sys configuration(only for F+G chassis)

Connect to the M6+ PRO -*** wirelessly, press and hold the M6+ PRO switch button for 3 seconds, and the M6+ PRO host wireless indicator will flash. On the computer side, select the following for direct connection. Wired is similar, no setup required.

 

12. BMW wired ISTA configuration(only for F+G chassis)

Connect the USB cable, press and hold the M6+ PRO switch button for 3S, and the M6+ PRO host wired indicator light will flash. The computer ISTA configuration is as follows:

 

13. BMW Wireless ISTA configuration(only for F+G chassis)

Connect to the M6+ PRO -*** wirelessly, press and hold the M6+ PRO switch button for 3 seconds, and the M6+ PRO host wireless indicator will flash. The computer side is selected as follows:

 

14. The mobile phone BWM APP adopts wireless connection. (only for F+G chassis)

Connect to the M6+ PRO -***, password: 123456789, press and hold the M6+ PRO switch button for 3 seconds, and the M6+ PRO host wireless indicator will flash.

 

15. Supported BMW models and years.

 

www.obdexpress.co.uk