If you were involved in a car accident, your airbag sensors may have been triggered and/or the airbags may have inflated. If either occurs, you need airbag repairs prior to driving your vehicle. If you fail to do so, you will not be properly protected in case of another accident.
Here, Obdexpress.co.uk will show you how to use CG100 Prog III to repair your airbag on BMW.
Preparation Tool:
- CG100 Main Unit
- EEPROM Adapter
- Chip soldering board
- BMW Airbag Module
- Screwdriver
- Tweezer
Procedures:
Connect CG100 III programmer to your laptop and run CG100 software to select “Airbag”
Select “European car”–>”BMW”–>”65.77-9122500″–>”95640″
Then remove the BMW airbag module shell,you will see the PCB
(7pieces in total, unscrew them and put them together)
Now remove the 95640 chip from PCB with the help of a heating tool
Solder it on chip soldering board
After welding is succeeful ,connect the quipment
Everything is ready,click “Start”
You can save the chip data file on your laptop to make a backup
After saving file,click “OK”,then it will start repair airbag data automatically.
Repairing BMW airbag chip 95640 with CG100 Programmer ssucceeded!
Video demo:
