ktm bench 1.20 tune 320d BMW with Bosch edc17cp02 ecu

Car model and ECU type: 320d bmw with bosch edc17cp02 ecu

 

Purpose: Read and write ECU and start the car

 

ECU tuning tool: ktm bench 1.20

 

Problem:

I connected power can and gpt pins on the corresponding numbers made a read but selected flash from the

(71) Bosch med17 tc1766 flash. It crashed during erasing and writing around 7 percent. No longer able to detect through gpt pins i opened ecu soldered boot wire onto pad inside and if i select (53) tc1766 micro 1504kb i can read and write successful but car will not start has lots of faults on the dash.

ktm bench 1 20 tune bosch edc17cp02 01 409x900 - ktm bench 1.20 tune 320d BMW with Bosch edc17cp02 ecu - ktm bench 1.20 tune 320d BMW with Bosch edc17cp02 ecu

 

How to solve?

When you failwrite file you erase 18000-1BFFF area. It’s BOSCH service loader area.

You must select 53 module, use write function and select off optimization write, select write all, include, service areas and [Other] option in ECU selection and not correct checksums.

 

You must select raw write. Not MEDC17. And your reading is enought to recover your ecu.

Read your file after crash and check 18000-1BFFF area.

 

53 module of your ktm bench 1.20 clone tool to use to check your file after the crash.

You must read your bad file in BOOT mode. And compare it with your original read.

ktm bench 1 20 tune bosch edc17cp02 02 - ktm bench 1.20 tune 320d BMW with Bosch edc17cp02 ecu -

 

Good luck!

(Visited 233 times, 1 visits today)
favicon - ktm bench 1.20 tune 320d BMW with Bosch edc17cp02 ecu - ktm bench 1.20 tune 320d BMW with Bosch edc17cp02 ecu