Firmware: Ktag 6.070 Software: Ksuite 2.08 Car: Ford Transit 2.2 cdi 2012g, block SID 208 Tips: Ford Transit 2.2 cdi 2012g. block SID 208. It is necessary to remove the soot. The manual says that first you need to connect the K-Tag to the OBD connector with a cable 144300T108. Click on Continue Reading →
Ktag should be able to program with Jtag, BDM and Boot protocols. However, I have no luck with Ktag 6.070 for Tricore BOOT; My way is to rework the board Before rework:Everything working fine (BDM, Kline etc.) except Tricore boot Connection OK, ID OK , begin reading ok , then jump when reading an Continue Reading →
It helps how to unlock, read and writeSimos PCR2.1 from VW Golf VI 1.6tdi. Look here: i have past last week trying many thinks on pcr2.1 and bench flashing . everything written below is tested and confirmed working by me on 4 ecus /cars ,only on chinese clone not reworked unit : fgtech v54 Continue Reading →
Is Ktag 7.026 better than Ktag 7.020? Is it worth buying a new tool just for this upgrade? See how do people think of this? Discussion at http://mhhauto.com/ 1 This 7.026 update is all ready available from EU. “Problem ” is resetting. NXP need replace when Continue Reading →
OBDexpress received a customer review of Ktag programmer. Look here: Hello Today i received my chinese ktag after i receive it i open case and see the board maybe best component not same first example resistor filter it’s good quality, not Continue Reading →
Thread: ktag sw 2.13 hw 6.070 internet connection solution I´m posting the solution to solve all grey in ktag 6.070 coz network connection is not allowed to use with Ktag programmers except Ktag 7.020. 1 install ksuite 2.08 2 download the file 3 the file have 3 parts (sd card, update too Continue Reading →
Copyright © 2018 | OBDexpress.co.uk
