MDJ8F3.M3 Read Write with Clone Kess, Ktag, MPPS: Work Fine

ECU type: MDJ8F3.M3 from Alfa Romeo Mito 1.3mjt

 

Purpose: read and write this control unit

 

ECU programmer to use:

Option 1. Clone Kess Ksuite

yes without problem can read and write this ecu type with kess clone

I have done a few car.

I have done Fiat Ducato 2015r MDJ8F3 about 10 stuck
and fiat 500 1.3 about 3 stuck without any problem.

read write mdj8f3m3 01 - MDJ8F3.M3 Read Write with Clone Kess, Ktag, MPPS: Work Fine - read and write MDJ8F3.M3

 

Option 2. Ktag clone

Ktag work fine but we need open ecu.

I knew that with ktag clone you could do it in boot mode. Then you have to open the ECU.

read write mdj8f3m3 02 - MDJ8F3.M3 Read Write with Clone Kess, Ktag, MPPS: Work Fine - read and write MDJ8F3.M3

 

Option 3. MPPS

The best tool is mpps. Mpps work perfectly on this ecu and do full backup on obd.

Once I wrote the MJD8DF with MPPS v18. It worked fine, I could read/write flash and EEPROM, so it’s possible to even clone those.

If You’re looking for a cheap tool for those ECUS, try original SMOK, not that expensive and can do all MJD8 and MJD9 ECUS without any problem.

 

Okay, guys hope it helps!

 

www.obdexpress.co.uk

favicon - MDJ8F3.M3 Read Write with Clone Kess, Ktag, MPPS: Work Fine - MDJ8F3.M3 Read Write with Clone Kess, Ktag, MPPS: Work Fine