I would like to know if it is possible to have the tab multidiag in the interface diagbox version 7.xx
as in this picture.
Yes, it can!!!
you need the multidiag software and the multidiag probe.
The “multidiag” tab only locks shortcuts to launch the multidiag software.
normally when we have multidiag, and when we want to have this shortcuts. When installing diagbox, put 700, at the end of the profile number that we put for example, in general we put 10FFF000 or 01FFF000, or 02FFF000 or 20FFF000. there it will be necessary to put 700 in the place of the 000s.
But as I said, it’s just a shortcut, nothing more ….
If you open diagbox to use multidiag, both use the shortcut directly on the board ^^
and if I remember correctly, first install multidiag, and then diagbox.
This is quoted from
http://www.lemondedudiagauto.com/t8263-diagbox-et-actia-multidiag#
Please TRY AT YOUR OWN LUCKY.
Usually, the clone actia 2016 is not advised to install in the interface diagbox, like this one
