Hello guys, today I’m going to show how to program 2021 Suzuki S Presso all keys lost by OBD. To finish this job, I’ll use Xhorse VVDI Key Tool Max(Key Tool Max Pro is also available), Autel MaxiIM IM508 & Xhorse Super Remote with built-in ID47 chip.
Prepared Remote via Key Tool Max
Vehicle remote >> Suzuki >> S-Cross SX4 ID47 2015
Because VVDI Key Tool Max does not have Suzuki S Presso option, so I’ll select S-Cross SX4 instead, which also has wireless function & ID47.
Having been prepared the remote, go ahead to next step.
Program Key via Autel IM508
Connect IM508 into OBD interface.
IMMO >> Accept >> Suzuki >> System selection >> IMMO status scan >> BCM(8-digit) >> Add key
Please switch Hazard ON.
Please switch ignition ON (when doing all keys lost, if cannot switch ignition ON, you can try the immobilizer box wire short-circuit).
OK >> Start
After the function is carried out, all keys will be cleared. These keys cannot be used unless they are learned again. If this function is required, please get all keys ready.
Select “Yes” to get the 8-digit PIN code.
Follow the guidance step according to key type, press “OK”:
Mechanical key: switch on ignition with keys that need to match.
Smart key: place the smart key which need to match on the push start button(key logo facing push start button).
Number of current keys: 1
Learning complete.
Press “Yes” to learn next key
Just repeat previous operation.
Number of current keys: 2
Press “No” to complete learning.
Let’s try the keys.
Both can normally start the car, remote also works well.
Well done.